Zeez F7 20×20 FC



Zeez F7 2020 Specifications:

★Mounting Holes 20×20
★Direct solder connection and board space for TBS Nano RX and TBS Unify Pro32 Nano providing the ultimate in clean stack installation.
★Up to 8S input (max 36V)
★5V BEC up to 3A continuous
★STM32F722 MCU (Support Betaflight, INav, Emuflight)
★MPU6000 Gyro/ACC for smooth performance
★128MB Onboard flash
★OSD chip Onboard
★6 available UARTS
★VTX switch to control the ON/OFF of the VTX directly from your transmitter (control via Betaflight with USER1 mode)
★LC Filter for 5V VTX and Camera
★USB Type C connector
★Onboard RGB LED distribution for clean wiring
★to the LED on the arm of the quad.
★8 Onboard RBG LED (compliant with FAI Rules)
★Logic Side and USB current protection

Zeez F7 2020 includes:

(1X) Zeez F7 2020 Flight Controller
(4X) Aluminum Standoff
(4X) Aluminum Nut
(1X) ESC to Flight Controller 8 Pin to 8 Pin JST SH 1.00mm connector
(1X) ESC to Flight Controller 8 Pin to Free wires (with JST SH crimp) JST SH 1.00mm connector
(1X) JST SH 8 Pin Plastic Housing
(1X) JST SH 10 Pin Plastic Housing
(2X) 2.00mm Header Pin for VTX connection
(2X) 2.54mm Header Pin for Receiver connection
(2X) Spare M3 rubber anti vibration for Flight Controller or ESC

Figyelem! Ha a repülés vezérlő nem indul el csak usb-ről, akkor a hibajelenséget csak akkor tudjuk garanciálisan elfogadni, ha még nem történt ráforrasztás a repülés vezérlőre. Forrasztás előtt kérjük, hogy mindig ellenőrizzétek! Forrasztási hibákból keletkezett hibákat garanciálisan nem tudjuk javítani.|Attention! If the flight controller starts only from, the error phenomenon can only be accepted under warranty if no solder has been made to the flight controller. Please always check before soldering! Defects caused by soldering cannot be repaired under warranty.