Pyrodrone F4 PDB FC (VTX PIT mód)

15 290 Ft

Készleten, szállítás akár 1 munkanap alatt!

Leírás

Kérjük, hogy ellenőrizd, hogy a megfelelő feszültség választó van összeforrasztva a VTX megtáplálásához!

Pyrodrone F4-PDB 30*30 flight controller is a dream come true for pilots who like using individual ESC.

 

Features:
- Built in PDB for individual ESC build
- Built in VTX switch (Pit mode) through Betaflight (No soldering or jumpers required)
- Selectable jumper 5V or Vbat to power VTX
- Built in Bluetooth module for Speedybee app
- BT can be turn off using USER2 mode switch
- Built in Camera Control pin with necessary resistor and capacitor near camera         connection
-All top solder pads for easy access and maintenance.
-Selectable internal current sensor or external current sensor from 4 in 1 ESC.
-Built in Secret Filter for vbat to VTX and camera
-Built in PIT swith using USER1 mode Switch.
-Built in Barometer

Specifications:

-MCU: STM32F405 216MH Proven noise free MPU6000
-Built in Betaflight OSD
-2-8S direct battery input (BEC can withstand 60V max)
-Buzzer pads for external buzzer
-3.3V 100ma, 5V 1.5A BEC
-Built in configurable Betaflight OSD
Led strip shares 5V with 5V/1.5A BEC
-6 UARTS. UART1 (INVERTER FOR SBUS),
UART2 (FREE),
UART3 (INVERTED TELEMETRY), use CLI command : Set tlm_halfduplex=off
UART4 (Free),
UART5 (Smart Audio)
UART6 (Free)
-Built in current sensor scale at 250
-Built in Baro meter
-Built in camera control pin with resistor and capacitor
-5 Full UARTS with RX AND TX pins
-Logical pin layout for cleanest build possible
-8 pin 4 IN 1 ESC plug
-Remapable LED pad for additional motor output
-TX3,RX3 can be used for I2C for external compass
-5V, VBAT selectable VTX and CAM power
-VTX pit mode switch (positive switch)
-36×36 PCB with 30.5×30.5 mounting holes

 

Includes:
1 x Pyrodrone F4 PDB - MPU6000 Flight Controller
5 x Rubber grommets
3 x 4in1 Socket connectors (8 pin, 9 pin, 10 pin)

Figyelem! Ha a repülés vezérlő nem indul el csak usb-ről, akkor a hibajelenséget csak akkor tudjuk garanciálisan elfogadni, ha még nem történt ráforrasztás a repülés vezérlőre. Forrasztás előtt kérjük, hogy mindig ellenőrizzétek! Forrasztási hibákból keletkezett hibákat garanciálisan nem tudjuk javítani.|Attention! If the flight controller starts only from, the error phenomenon can only be accepted under warranty if no solder has been made to the flight controller. Please always check before soldering! Defects caused by soldering cannot be repaired under warranty.